# Nozzle temperature showing 107 when off

**URL:** <https://forum.sovol3d.com/t/nozzle-temperature-showing-107-when-off/5211>\
**Category:** Sovol SV02\
**Created:** [June 23, 2024, 2:02pm UTC](https://forum.sovol3d.com/t/nozzle-temperature-showing-107-when-off/5211 "2024-06-23T14:02:52Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![storeman](https://avatars.discourse-cdn.com/v4/letter/s/e36b37/32.png) [@storeman](https://forum.sovol3d.com/u/storeman)\
**Post date:** [June 23, 2024, 2:02pm UTC](https://forum.sovol3d.com/t/nozzle-temperature-showing-107-when-off/5211/1 "2024-06-23T14:02:52Z")

</div>

The nozzle temperature is showing 107 when not in use. Have tried 2 new thermistors and till the same. Swapped over the nozzle & bed thermistor at the board and the fault stays with the nozzle so proving the fault is on the board. Is there anyway of getting the firmware to use thermistor 1 instead of therm0

I have tried setting thermistor 1 as enabled and setting thermistor 2 pin but still showing the temp at therm 1