# No longer sticking to bed

**URL:** <https://forum.sovol3d.com/t/no-longer-sticking-to-bed/4809>\
**Category:** Sovol SV06 Plus\
**Created:** [April 5, 2024, 4:17pm UTC](https://forum.sovol3d.com/t/no-longer-sticking-to-bed/4809 "2024-04-05T16:17:38Z")\
**Posts on this page:** 1\
**Showing post:** 13

<div class="post-metadata">

**Author:** ![Lion](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/lion/32/5586_2.png) [@Lion](https://forum.sovol3d.com/u/Lion)\
**Post date:** [April 6, 2024, 10:21pm UTC](https://forum.sovol3d.com/t/no-longer-sticking-to-bed/4809/13 "2024-04-06T22:21:10Z")

</div>

Read:

> [@Z calibration buggy](https://forum.sovol3d.com/t/z-calibration-buggy/2747):
>
> I am not sure what I am doing wrong, but this is my flow (my nozzle is heated to 120c and bed is heated to 60c): I press auto align Z, and wait until it is done I take a piece of paper and hone the Z down until the paper is barely scratched by the nozzle I press save I insert the paper in-between the bed and nozzle again, but this time the gap is wide, so I have to adjust again I press save Now the paper can barely fit, so I have to move it a bit up again I press save If I am lucky, I can now …

---

_[View the full topic](https://forum.sovol3d.com/t/no-longer-sticking-to-bed/4809)._