# New with issues..🤣

**URL:** <https://forum.sovol3d.com/t/new-with-issues/4583>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Created:** [February 22, 2024, 7:24pm UTC](https://forum.sovol3d.com/t/new-with-issues/4583 "2024-02-22T19:24:09Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![RacerXL](https://avatars.discourse-cdn.com/v4/letter/r/ea666f/32.png) [@RacerXL](https://forum.sovol3d.com/u/RacerXL)\
**Post date:** [February 22, 2024, 7:24pm UTC](https://forum.sovol3d.com/t/new-with-issues/4583/1 "2024-02-22T19:24:09Z")

</div>

All setup done per instructions.

Printer was fine and then not.

After i start a print the first line that prints down the left side of the bed (not sure what its called) starts too high ( starts extruding with z axis too high) and is not in the correct offset -1.60 for about 1 cm and then lowers to the correct height. Then its returns on that same line (2nd layer) and raises about the same location and extudes a bit more but pulls the filament a little to the center of the bed (end looks like a J) and is not adhered to the bed. Any idea why this is happening? Other than that it prints fine once the actual print starts.

---

<div class="post-metadata">

**Author:** ![Lion](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/lion/32/5586_2.png) [@Lion](https://forum.sovol3d.com/u/Lion)\
**Post date:** [February 23, 2024, 12:25pm UTC](https://forum.sovol3d.com/t/new-with-issues/4583/2 "2024-02-23T12:25:24Z")

</div>

Do you a camera setup…sometimes my Beagle Camera would freak up like this.  
Also, try a different SD Card.