# New Sovol sv08 Crashes when printing

**URL:** <https://forum.sovol3d.com/t/new-sovol-sv08-crashes-when-printing/8599>\
**Category:** Sovol SV08\
**Tags:** bed-leveling\
**Created:** [August 28, 2025, 5:00pm UTC](https://forum.sovol3d.com/t/new-sovol-sv08-crashes-when-printing/8599 "2025-08-28T17:00:18Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![mark9976](https://avatars.discourse-cdn.com/v4/letter/m/0ea827/32.png) [@mark9976](https://forum.sovol3d.com/u/mark9976)\
**Post date:** [August 28, 2025, 5:00pm UTC](https://forum.sovol3d.com/t/new-sovol-sv08-crashes-when-printing/8599/1 "2025-08-28T17:00:18Z")

</div>

I just got my sovol unit built this morning and I did the z offset calibration but when it goes to the front right corner it trys to go below the bed, causing a crash.

When trying to print the printer will home just fine but then it will go to the font left and crash into the bed.

Any ideas what might be going on with the printer? is this just a GCODE file issue or something more?

---

<div class="post-metadata">

**Author:** ![mark9976](https://avatars.discourse-cdn.com/v4/letter/m/0ea827/32.png) [@mark9976](https://forum.sovol3d.com/u/mark9976)\
**Post date:** [August 28, 2025, 5:30pm UTC](https://forum.sovol3d.com/t/new-sovol-sv08-crashes-when-printing/8599/2 "2025-08-28T17:30:35Z")

</div>

I think updating the firmware fixed the issue.