# Mesh bed levelling
**URL:** https://forum.sovol3d.com/t/mesh-bed-levelling/6087
**Category:** Sovol SV06 ACE
**Created:** [November 26, 2024, 3:47pm UTC](https://forum.sovol3d.com/t/mesh-bed-levelling/6087 "2024-11-26T15:47:48Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@luwi66](https://forum.sovol3d.com/u/luwi66)
#### Post date: [November 26, 2024, 3:47pm UTC](https://forum.sovol3d.com/t/mesh-bed-levelling/6087/1 "2024-11-26T15:47:48Z")
For every print you have to wait about two or three minutes for
- hotend temp down to 130°
- bed levelling (at least?) 9 points
- heat up bed
- heat up hotend
and only then the print really starts.
While ABL is fine, I wonder if Sovol could store the mesh data and allow to use it for the next print.
So, for example make mesh bed levelling for every fifth print or adjustable number.
---
### Author:  [@mich0111](https://forum.sovol3d.com/u/mich0111)
#### Post date: [November 26, 2024, 3:53pm UTC](https://forum.sovol3d.com/t/mesh-bed-levelling/6087/2 "2024-11-26T15:53:30Z")
You know, waiting 2-3 minutes to print, if you save tens of minutes afterwards, it’s not so bad.
---
### Author:  [@luwi66](https://forum.sovol3d.com/u/luwi66)
#### Post date: [November 26, 2024, 4:22pm UTC](https://forum.sovol3d.com/t/mesh-bed-levelling/6087/3 "2024-11-26T16:22:35Z")
Maybe I am a bit impatient, but I know this feature from other printers (there is a Marlin code for this, M420), so I wonder if it could be useful (and easy to implement?)
---
### Author:  [@luwi66](https://forum.sovol3d.com/u/luwi66)
#### Post date: [November 26, 2024, 4:51pm UTC](https://forum.sovol3d.com/t/mesh-bed-levelling/6087/4 "2024-11-26T16:51:53Z")
Please forget my comment, I just saw that the position of the bed levelling points depend upon the print model position, so they vary and storing and recalling makes no sense.