# Layer Lines Showing Up Only on Right Side of Print

**URL:** <https://forum.sovol3d.com/t/layer-lines-showing-up-only-on-right-side-of-print/335>\
**Category:** Sovol SV03 BIG DD 3D printer\
**Created:** [June 4, 2022, 10:52pm UTC](https://forum.sovol3d.com/t/layer-lines-showing-up-only-on-right-side-of-print/335 "2022-06-04T22:52:20Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![Ciol](https://avatars.discourse-cdn.com/v4/letter/c/e274bd/32.png) [@Ciol](https://forum.sovol3d.com/u/Ciol)\
**Post date:** [June 9, 2022, 5:52am UTC](https://forum.sovol3d.com/t/layer-lines-showing-up-only-on-right-side-of-print/335/4 "2022-06-09T05:52:49Z")

</div>

Thank you for your quick reply  
To clarify, I’m not part of the sovol team. I’m just a nice guy trying to help and got promoted to admin in this forum by the sovol team as a result.

Your answer to the Raft, makes me think that the z offset was not setup properly. Please check this other post in the forum where I linked a video done by the sovol team on how it should be done

> [@Help on print not sticking](https://forum.sovol3d.com/t/help-on-print-not-sticking/251/19):
>
> Here is a video I found that the Sovol Team did to explain it. You just need to follow these steps, but yes you need to feel the grip the nozzle has on a piece of paper. [[Bed Leveling Guide on SOVOL SV03! Auto- leveling] ](https://www.youtube.com/watch?v=ajCTGUd-FW0) I’m guessing that this wasn’t done, and it resulted it in the nozzle being too high on the first layer which will cause the issue you described

Let me know if this works or not.

After this is first layer issue is fixed, then let’s see if your print line issue remains.  
It’s best to move by fixing one issue at a time and having a good first layer is key.  
So let me know if this helped or not.

---

_[View the full topic](https://forum.sovol3d.com/t/layer-lines-showing-up-only-on-right-side-of-print/335)._