# Issues with SV08 resume print function

**URL:** <https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245>\
**Category:** Sovol SV08\
**Created:** [December 12, 2024, 8:03pm UTC](https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245 "2024-12-12T20:03:39Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![PhriedFrog](https://avatars.discourse-cdn.com/v4/letter/p/dbc845/32.png) [@PhriedFrog](https://forum.sovol3d.com/u/PhriedFrog)\
**Post date:** [December 12, 2024, 8:03pm UTC](https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245/1 "2024-12-12T20:03:39Z")

</div>

How do I put the correct G-Code into my prints so that when I pause the print to change filament to make a multicolored print I can resume it? I used an M25 code to pause and when I try to resume after putting the new filament on the console says that it can’t resume because the print isn’t paused.

---

<div class="post-metadata">

**Author:** ![mich0111](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/mich0111/32/1176_2.png) [@mich0111](https://forum.sovol3d.com/u/mich0111)\
**Post date:** [December 12, 2024, 8:08pm UTC](https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245/2 "2024-12-12T20:08:14Z")

</div>

Is the pause feature has to be enable before on your printer ?

---

<div class="post-metadata">

**Author:** ![mistral](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/mistral/32/2118_2.png) [@mistral](https://forum.sovol3d.com/u/mistral)\
**Post date:** [December 12, 2024, 9:58pm UTC](https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245/3 "2024-12-12T21:58:49Z")

</div>

In the configuration files, there is (in the stack configuration) :

```auto
[gcode_macro M600]
gcode:
    PAUSE STATE=filament_change

```

The implementation of M600 including others fine tuning.

---

<div class="post-metadata">

**Author:** ![PhriedFrog](https://avatars.discourse-cdn.com/v4/letter/p/dbc845/32.png) [@PhriedFrog](https://forum.sovol3d.com/u/PhriedFrog)\
**Post date:** [December 13, 2024, 3:27pm UTC](https://forum.sovol3d.com/t/issues-with-sv08-resume-print-function/6245/4 "2024-12-13T15:27:09Z")

</div>

Solved it. Found the printer config button and added the M600 to the filament changes g-code section and it works perfectly now