# Interesting design targets, budget allocations

**URL:** <https://forum.sovol3d.com/t/interesting-design-targets-budget-allocations/3445>\
**Category:** Sovol Klipperized SV07\
**Created:** [September 8, 2023, 3:26pm UTC](https://forum.sovol3d.com/t/interesting-design-targets-budget-allocations/3445 "2023-09-08T15:26:00Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![meicalnissyen](https://avatars.discourse-cdn.com/v4/letter/m/ac91a4/32.png) [@meicalnissyen](https://forum.sovol3d.com/u/meicalnissyen)\
**Post date:** [September 8, 2023, 3:26pm UTC](https://forum.sovol3d.com/t/interesting-design-targets-budget-allocations/3445/1 "2023-09-08T15:26:00Z")

</div>

hehehe

well, I’m new to the party. started at 6

have 2, run em a good bit.

got a plus, which a pretty poor chassis, tough to tune harmonics out of, which the bad firmware exacerbates, but its bigger.

think Lane Bryant. bigger… not better, but bigger

anyway, I say all that because its pretty clear from what I saw prior and read aftr, buying, that this was a half assed project in a box I ordered.

knowing that upfront and getting it on that stupid cheep mainsite sale a month back, and the fairly good support I have been getting on the AMAZONSOVOL, made getting one an easy choice.

dunno how many of you removed the big burr in the Z colum mating surface, I did.

the Y belt tensioner is a lovely bit of design. vastly better than the crap L brackets on the 6, and the oops.  
but dimensioned by the the same idiot that been trying to bend Y motorshafts since day 1. The L brackets I can mitigate by drilling and tapping a second set of holes, 8mm over, then mount the pulley correctly. not possible on a 7.

drilled and tapped a 3mm in the center of the sled, and a 3.2 in the center of the bed.  
so, 5 point bed mesh {flex}

Damn sled is not square to the Y vslot, so I’m correcting that before powering it up, wouldnt matter if you were keeping the Ender style bed mount.

Then the hardpart starts…  
new computer stuff for the old machinist to learn

---

<div class="post-metadata">

**Author:** ![ednewbold](https://avatars.discourse-cdn.com/v4/letter/e/71c47a/32.png) [@ednewbold](https://forum.sovol3d.com/u/ednewbold)\
**Post date:** [September 11, 2023, 2:33am UTC](https://forum.sovol3d.com/t/interesting-design-targets-budget-allocations/3445/2 "2023-09-11T02:33:47Z")

</div>

> [@meicalnissyen](#):
>
> AMAZONSOVOL

???

---

<div class="post-metadata">

**Author:** ![meicalnissyen](https://avatars.discourse-cdn.com/v4/letter/m/ac91a4/32.png) [@meicalnissyen](https://forum.sovol3d.com/u/meicalnissyen)\
**Post date:** [September 15, 2023, 5:45pm UTC](https://forum.sovol3d.com/t/interesting-design-targets-budget-allocations/3445/3 "2023-09-15T17:45:30Z")

</div>

[amazonus@sovol3d.com](mailto:amazonus@sovol3d.com)