# Initial heat up temp going to 250

**URL:** <https://forum.sovol3d.com/t/initial-heat-up-temp-going-to-250/4472>\
**Category:** Sovol Klipperized SV07\
**Created:** [February 8, 2024, 7:18am UTC](https://forum.sovol3d.com/t/initial-heat-up-temp-going-to-250/4472 "2024-02-08T07:18:36Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![StueyD](https://avatars.discourse-cdn.com/v4/letter/s/85f322/32.png) [@StueyD](https://forum.sovol3d.com/u/StueyD)\
**Post date:** [February 8, 2024, 7:18am UTC](https://forum.sovol3d.com/t/initial-heat-up-temp-going-to-250/4472/1 "2024-02-08T07:18:36Z")

</div>

Hi all,

So using cura, I’m changing my temps to 205, but when I start my prints it warms upto 250 then comes back down.

The problem is it’s causing bubbling on that first layer.

How do I stop it doing this on the warm up.

Cheers  
Stu