# First issue with sv06 Plus
**URL:** https://forum.sovol3d.com/t/first-issue-with-sv06-plus/3312
**Category:** Sovol SV06 Plus
**Created:** [August 19, 2023, 4:41am UTC](https://forum.sovol3d.com/t/first-issue-with-sv06-plus/3312 "2023-08-19T04:41:38Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@Haaky](https://forum.sovol3d.com/u/Haaky)
#### Post date: [August 19, 2023, 4:41am UTC](https://forum.sovol3d.com/t/first-issue-with-sv06-plus/3312/1 "2023-08-19T04:41:38Z")
Does anyone know why this is happening?
When my print finishes and the Y axis moves forward to reveal the print, the bed or the bearing mount slams into the frame.
If i move the Y axis to its maximum it only reads as moving to 290 not 300
The X axis moves all the way to 300.
By the way, so far every print has turned out amazing.
---
### Author:  [@mich0111](https://forum.sovol3d.com/u/mich0111)
#### Post date: [August 19, 2023, 12:16pm UTC](https://forum.sovol3d.com/t/first-issue-with-sv06-plus/3312/2 "2023-08-19T12:16:01Z")
Hi,
Is the bed’s cable free ?
Check that the cable does not get caught in the frame.
---
### Author:  [@Haaky](https://forum.sovol3d.com/u/Haaky)
#### Post date: [August 19, 2023, 4:51pm UTC](https://forum.sovol3d.com/t/first-issue-with-sv06-plus/3312/3 "2023-08-19T16:51:12Z")
Yup that kinda what it was.
I had the printer to close to the wall, so when it would home the cable support i printed would hit the wall then when the bed moved forward it was basically 10mm off
My bad, again:)