# Fillament load dosent work

**URL:** <https://forum.sovol3d.com/t/fillament-load-dosent-work/8045>\
**Category:** Sovol Klipperized SV07\
**Created:** [June 11, 2025, 8:16pm UTC](https://forum.sovol3d.com/t/fillament-load-dosent-work/8045 "2025-06-11T20:16:18Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![CaydeNine](https://avatars.discourse-cdn.com/v4/letter/c/2acd7d/32.png) [@CaydeNine](https://forum.sovol3d.com/u/CaydeNine)\
**Post date:** [June 11, 2025, 8:16pm UTC](https://forum.sovol3d.com/t/fillament-load-dosent-work/8045/1 "2025-06-11T20:16:18Z")

</div>

Reloading filament doesn’t work.  
When I insert the filament and tell the printer to load it, it pulls it in a bit and then stops.  
Even if I let the printer run for a while, nothing happens.  
I cleaned the print head, but that didn’t help either.

please help what can i do?

---

<div class="post-metadata">

**Author:** ![cardoc](https://avatars.discourse-cdn.com/v4/letter/c/ec9cab/32.png) [@cardoc](https://forum.sovol3d.com/u/cardoc)\
**Post date:** [June 11, 2025, 10:01pm UTC](https://forum.sovol3d.com/t/fillament-load-dosent-work/8045/2 "2025-06-11T22:01:29Z")

</div>

You most likely have a piece of filament stuck in just below the feed gears.

Take off the outer cover, unplug the lights and set aside. Remove the tension screw (note the order of washer, spring, bolt) and swing the lever all the way down and look. It may be necessary to remove the heater/heatbreak and use the “push tool” from the bottom.

> [@Filament won't advance but there doesn't seem to be a clog?](https://forum.sovol3d.com/t/filament-wont-advance-but-there-doesnt-seem-to-be-a-clog/7511):
>
> Part way through a print, my filament stopped extruding. I thought it was a clog but I can thread the acupuncture needle clear up to its spring when putting it into the nozzle. I can also get it really low when putting it through the filament input on the motor so I’m starting to think it’s not a clog and maybe there is filament stuck in the gears somehow? My manual doesn’t have any instructions on taking the print head apart to check the gears, the github for the SV06 Plus Ace seems to be basi…