# Doesn't stop going down when leveling (homing sensors issue?) **URL:** \ **Category:** Sovol SV08\ **Tags:** bed-leveling\ **Created:** [November 24, 2025, 4:32pm UTC](https://forum.sovol3d.com/t/doesnt-stop-going-down-when-leveling-homing-sensors-issue/9077 "2025-11-24T16:32:25Z")\ **Posts on this page:** 1\ **Showing post:** 9
**Author:** ![wrusman](https://avatars.discourse-cdn.com/v4/letter/w/8dc957/32.png) [@wrusman](https://forum.sovol3d.com/u/wrusman)\ **Post date:** [November 27, 2025, 3:03pm UTC](https://forum.sovol3d.com/t/doesnt-stop-going-down-when-leveling-homing-sensors-issue/9077/9 "2025-11-27T15:03:58Z")
check you nozzle! the first versions of the nozzle do not have a setscrew and can disassemble themselve with these issues. This will cause exactly what you video shows because it cannot lower the gantry far enough anymore to trigger the probe. This has cost me a build plate and a clean underpants > [@Mayor crash after many flawless prints](https://forum.sovol3d.com/t/mayor-crash-after-many-flawless-prints/5632): > > Tonight I started a print like I would normally do from orcaslicer. After about an hour I went to check the camera from my phone and had the shock of my life: there was terror in every image. The print head was dragging around blobs of molten plastic together with the detached extruder case along the printbed. I quickly stopped the printer and ran upstairs. This is what I found After examining the w… --- _[View the full topic](https://forum.sovol3d.com/t/doesnt-stop-going-down-when-leveling-homing-sensors-issue/9077)._