# Difficulty installing the AB axis assembly

**URL:** <https://forum.sovol3d.com/t/difficulty-installing-the-ab-axis-assembly/5969>\
**Category:** Sovol SV08\
**Created:** [November 8, 2024, 9:48pm UTC](https://forum.sovol3d.com/t/difficulty-installing-the-ab-axis-assembly/5969 "2024-11-08T21:48:37Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![mistere](https://avatars.discourse-cdn.com/v4/letter/m/e480ec/32.png) [@mistere](https://forum.sovol3d.com/u/mistere)\
**Post date:** [November 8, 2024, 9:48pm UTC](https://forum.sovol3d.com/t/difficulty-installing-the-ab-axis-assembly/5969/1 "2024-11-08T21:48:37Z")

</div>

I’m having trouble getting the AB axis assembly to fit. It seems slightly too long (front to back) to fit between the Z-axis blocks. If the front goes down to the mounting surface the rear hits the top of the Z-axis block and won’t go down to the mounting surface. I have tried repeatedly to get it to fit by carefully lowering it into all 4 corners but it will sit on top of all 4 mounting Z-axis blocks in that case ☹  
Do I have to remove the top frame, loosen the Z3 and Z4 corners, and pull them slightly forward for this to fit or is there some adjustment I can make to achieve that?  
Won’t it be too tight once everything is tightened up again?  
Thanks in advance - I’m looking forward to getting this going!

---

<div class="post-metadata">

**Author:** ![mistere](https://avatars.discourse-cdn.com/v4/letter/m/e480ec/32.png) [@mistere](https://forum.sovol3d.com/u/mistere)\
**Post date:** [November 9, 2024, 1:59am UTC](https://forum.sovol3d.com/t/difficulty-installing-the-ab-axis-assembly/5969/2 "2024-11-09T01:59:24Z")

</div>

I tinkered with it a bit more and then went ahead and loosened it up as I described and fit the AB axis assembly in place. It went together just fine. Since then I’ve printed a Benchy and it appears to work just fine!

---

<div class="post-metadata">

**Author:** ![system](https://canada1.discourse-cdn.com/flex030/uploads/sovolforum/original/1X/c8366f7d43f008332e7c6dcb896aad6deac01a21.jpeg) [@system](https://forum.sovol3d.com/u/system)\
**Post date:** [November 16, 2024, 1:59am UTC](https://forum.sovol3d.com/t/difficulty-installing-the-ab-axis-assembly/5969/3 "2024-11-16T01:59:44Z")

</div>

Closed on November 16, 2024, 1:59am UTC

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.
