# Changing the nozzle temperature in the z‑offset calibration macro.

**URL:** <https://forum.sovol3d.com/t/changing-the-nozzle-temperature-in-the-z-offset-calibration-macro/10247>\
**Category:** Sovol SV08\
**Created:** [August 4, 2026, 1:41pm UTC](https://forum.sovol3d.com/t/changing-the-nozzle-temperature-in-the-z-offset-calibration-macro/10247 "2026-08-04T13:41:54Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Alien\_Soldier](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/alien_soldier/32/6296_2.png) [@Alien\_Soldier](https://forum.sovol3d.com/u/Alien_Soldier)\
**Post date:** [August 4, 2026, 1:41pm UTC](https://forum.sovol3d.com/t/changing-the-nozzle-temperature-in-the-z-offset-calibration-macro/10247/1 "2026-08-04T13:41:54Z")

</div>

Greetings! Please tell me. (The text is technically translated)  
How to change the nozzle temperature in the macro while performing z-offset calibration?

I’ve been reading this topic: [How to best set z offset for higher temps than the built in macros - Sovol SV08 - Sovol3d forum](https://forum.sovol3d.com/t/how-to-best-set-z-offset-for-higher-temps-than-the-built-in-macros/8747)

However, when the nozzle cleaning temperature changes, the calibration temperature does not change.  
For example: I change the nozzle cleaning temperature in the macro to 220 degrees. But the temperature during calibration remains 240 degrees.

I haven’t been able to find a solution to this problem; I really hope for your help.

I need to lower the temperature for my plastic during calibration — it’s higher than necessary.

---

<div class="post-metadata">

**Author:** ![HandyDoodads](https://avatars.discourse-cdn.com/v4/letter/h/43a26b/32.png) [@HandyDoodads](https://forum.sovol3d.com/u/HandyDoodads)\
**Post date:** [August 4, 2026, 3:39pm UTC](https://forum.sovol3d.com/t/changing-the-nozzle-temperature-in-the-z-offset-calibration-macro/10247/2 "2026-08-04T15:39:05Z")

</div>

On the Sovol Zero I have raised the nozzle cleaning temperature to as high as 260 C but the temperature for Z calibration remains at 130 C. I don’t want a long wait for the nozzle to cool down before calibration so I disabled nozzle cleaning as I mostly print high temperature filaments. I put Z offset adjustments in my slicer’s custom g code section of the filament profiles and zero the offset adjust in the START\_PRINT macro. I wish Sovol would embrace open source and release the full firmware code.