# Autohoming / Bedleveling not working

**URL:** <https://forum.sovol3d.com/t/autohoming-bedleveling-not-working/10168>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Tags:** homing, leveling, advice\
**Created:** [July 2, 2026, 7:48am UTC](https://forum.sovol3d.com/t/autohoming-bedleveling-not-working/10168 "2026-07-02T07:48:05Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![pbogers](https://avatars.discourse-cdn.com/v4/letter/p/3da27b/32.png) [@pbogers](https://forum.sovol3d.com/u/pbogers)\
**Post date:** [July 2, 2026, 10:29am UTC](https://forum.sovol3d.com/t/autohoming-bedleveling-not-working/10168/2 "2026-07-02T10:29:24Z")

</div>

I had this also a time ago. The vertical detector on the printhead was moved a little bit.

Found some topic of re-adjusting/resetting on this forum; forgot where exactly, hope you can find it 🙂

Edit : found [Autohoming / Bedleveling not working - Sovol SV06 Fully Open Source 3D Printer - Sovol3d forum](https://forum.sovol3d.com/t/autohoming-bedleveling-not-working/10168) and [Auto Home crashes into bed - Sovol SV06 Plus - Sovol3d forum](https://forum.sovol3d.com/t/auto-home-crashes-into-bed/4909)

---

_[View the full topic](https://forum.sovol3d.com/t/autohoming-bedleveling-not-working/10168)._