# Auto Home crashes into bed

**URL:** <https://forum.sovol3d.com/t/auto-home-crashes-into-bed/4909>\
**Category:** Sovol SV06 Plus\
**Created:** [April 19, 2024, 9:23pm UTC](https://forum.sovol3d.com/t/auto-home-crashes-into-bed/4909 "2024-04-19T21:23:57Z")\
**Posts on this page:** 1\
**Showing post:** 1

<div class="post-metadata">

**Author:** ![Splatter](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/splatter/32/1482_2.png) [@Splatter](https://forum.sovol3d.com/u/Splatter)\
**Post date:** [April 19, 2024, 9:23pm UTC](https://forum.sovol3d.com/t/auto-home-crashes-into-bed/4909/1 "2024-04-19T21:23:57Z")

</div>

Hello,  
Had to buy a new sensor and after I’ve installed the new one I can’t get the printer to work right. Whenever I try to calibrate it, it has to do an auto home first and it always crashes into the bed so I have to power it off.

The sensors red light is on, it is mounted correctly and at the correct height. I flashed the firmware and I reset the eeprom several times.

I’ve had the problem before and fixed it but that was a while ago and I can’t recall exactly what I did.

---

_[View the full topic](https://forum.sovol3d.com/t/auto-home-crashes-into-bed/4909)._