# 2 Problems with my printer

**URL:** <https://forum.sovol3d.com/t/2-problems-with-my-printer/8982>\
**Category:** Sovol Klipperized SV07\
**Created:** [November 10, 2025, 5:37pm UTC](https://forum.sovol3d.com/t/2-problems-with-my-printer/8982 "2025-11-10T17:37:53Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![PK63015](https://avatars.discourse-cdn.com/v4/letter/p/bc8723/32.png) [@PK63015](https://forum.sovol3d.com/u/PK63015)\
**Post date:** [November 10, 2025, 5:37pm UTC](https://forum.sovol3d.com/t/2-problems-with-my-printer/8982/1 "2025-11-10T17:37:53Z")

</div>

My Y Axis is out of alignment. It tries to print off the back of the print. The purge line prints to the Heated Bed connection.

Another problem I have is when I try the Z Tilt it fails saying the increments are increasing.

Thank you for any help.

---

<div class="post-metadata">

**Author:** ![cardoc](https://avatars.discourse-cdn.com/v4/letter/c/ec9cab/32.png) [@cardoc](https://forum.sovol3d.com/u/cardoc)\
**Post date:** [November 11, 2025, 4:23pm UTC](https://forum.sovol3d.com/t/2-problems-with-my-printer/8982/2 "2025-11-11T16:23:48Z")

</div>

> [@PK63015](#):
>
> My Y Axis is out of alignment.

The axis is aligned every time it is “homed”. The sensorless homing process moves the plate until the motor stalls. Something is blocking your bed from moving freely to the rear.

> [@PK63015](#):
>
> Another problem I have is when I try the Z Tilt it fails saying the increments are increasing.

Try adjusting the roller on the bottom of the toolhead. Mine was loose allowing the toolhead to tip slightly. Turning the eccentric post to eliminate the shake fixed my machine.